#Unable to load mail system support. #Unable to read write-only property.#Unable to write read-only property. Cannot start scanning ! Could not start print job. Data transfer failed.9Communication error (sending failed). Destination disk drive is full.5Unable to read from %1, it is opened by someone else.AUnable to write to %1, it is read-only or opened by someone else..An unexpected error occurred while reading %1..An unexpected error occurred while writing %1. ERROR ! Error or Warning Miss Calibration Data !)Please take following calibration steps: @1. Select one of following two methods to calibrate the scanner:E (a) If you have the specific calibration paper, put the scanner on1 the tray and insert the calibration paper.F (b) If you have no calibration paper, remove the scanner out of theG tray and put it on a blank paper that is wider than the scanner.(2. Click START to calibrate the scanner.B3. If the warming up dialog appeared after you click START, please Please check the cable.+Scanner is not warmed up, please try again.8Note ! Scanner is not connected. Please check the cable. Communication error (receiving failed). Run-time error