( FATAL ERROR ) %s ARC: Start (%.15lf, %.15lf), End (%.15lf, %.15lf), Center (%.15lf, %.15lf), IncAng %.15lf Arc is too small. Centre : ( %lf, %lf ), Start point : ( %lf, %lf ). Cannot enable optimizer Cannot start group Error Temp filename too long Error calculating areas of part %s Error in loading the pre-processed data for Part %s. Part not considered for nesting Error in pdf generation Error in the part %s for splitting as hole and material Error type is unknown File : %s, Line : %d. Error while reading the input file. File : %s. Error reading NIP file. File : %s. The error file can not be opened. Invalid state. Can not start process of adding informatio nested parts. Invalid state. Can not start setting sequencing parameters. Invalid state. Can not start the callback registration. Invalid state. Can not start the cluster definition process. Invalid state. Can not start the order. Invalid state. Can not start the parameter input. Invalid state. Can not start the part list input. Invalid state. Can not start the sequencing. Invalid state. There was an error in Inquiry of Overlap Utility. Invalid state. There was an error in checking Overlap LINE: Start (%.15lf, %.15lf), End (%.15lf, %.15lf) Licensing Error Message: START PART START SHEET