9/11/13: 1=Start to capture Arg1 = 0 Control IPS, 0:Disable IPS, 1: Enable IPS Arg2 = (HRX), Start Address Error cmd string Error dbg flag Infra Disconnect Roaming Start Cnt = %lu Rx Reorder Enable = %x Type 0 => Enable this function cmd 13 4 0 0/1 --> disable/enable CTSToSelf cmd 14 0 1/0 (Enable or disable) dbgcmd 14 0 1 --> Enable the Bandwidth autoswitch < === N62CAPIndicateIncomAssocStart () < === SelectNetworkBySSID(): Do not start IBSS for Join Only! < === SelectNetworkBySSID(): Do not start IBSS if RT_JOIN_NETWORKTYPE_INFRA! < === Set OID_RT_DBG_LEVEL: MH_OID_CCX_ENABLE : %d ===> N62CAPIndicateIncomAssocStart () AP_CheckRSNIE bWPSEnable %d AP_StartApRequest(): Start S/W Beacon.... Drop the EAPOL-start packet. Enable AFE Macro Block's Bandgap Enable AFE Mbias Enable AFE clock source Enable CPU fail ! Enable DBG COMP = Fail to enable ASPM. Cannot find the Bus of PCI(Bridge). Failed to restart port %d after change of Op Mode. Status = 0x%08x GetScanInfo(): ERROR pMgntInfo-> state_Synchronization_Sta = %d HW WoWLAN enable = %#x HelperPortHandleMiniportRestart failed 0x%x IPSEnable(): Enable IPS mode JoinRequest():RT_START_IBSS - Do not start IBSS at channel(%d). JoinTimeout(): Start an IBSS MgntLinkStatusWatchdog(): Infra. client => start roaming... OnCcxTsmIE(): TSID(%d) enable TSM State(%#X)+++++ P2PCommonChannelArrived(): Recv ProbeReq from the target device = > start Group Formation P2PDeviceDiscovery(): delay start after %u (ms), StateBeforeScan: %u P2PMgntTimerCallback(): Start Device Discovery: loop times: %u P2POnGONReq(): Start waiting for user input for 2 min PHY_SetMonitorMode8192S(): enable monitor mode PlatformEnableASPM(): Fail to enable ASPM. Cannot find the Bus of PCI(Bridge). ReadAdapterInfo8187(): Enable dot11d when RT_CHANNEL_DOMAIN_GLOBAL_DOAMIN! Set OID_RT_WPS_LED_CTL_START: start LED blinking 0.3s Set OID_RT_WPS_LED_CTL_START_BOTTON: start LED blinking 0.3s SetTsmRequest(): TSM_ACTION_START on TSID(%d) Start 4-way handshake because of EAPOL-start. Start Active Scanning...... Start Beacon Table mode...... Start Passive Scanning...... TsStartAddBaProcess(): Delayed Start ADDBA after 60 sec!! TsStartAddBaProcess(): Immediately Start ADDBA now!! [FW CMD] [New Version] Set DIG enable or resume!!